Tapered plugs chillers and heat exchangers

Tapered plugs are used to repair and stop leaks in condensers, chillers and  heat exchangers. They are driven into tube ends with a soft faced  hammer until seated and sealed tight eliminating  future leaks. Welding is optional depending on your application. Select a plug where the middle diameter will approximately match your tubing ID. It is best not to drive the plug in … Read More

Machined White UHMW Plastic

New machined white UHMW plastic T-nut compared to a worn green reprocessed part. If your machine or equipment is wearing out, don’t replace the whole machine with an expensive new one.  Have MLP reverse engineer and machine a replacement part(s) and keep that equipment running. Machined White UHMW Plastic

Laser Engraved part

Here is a Stainless steel threaded adapter, 1-1/4 -7 by 7/8-9, produced by MLP.  Notice that the part includes a laser engraved part number.  Another example of the fine quality work made in the USA by MLP. Laser Engraved part

Utilizing our CNC Lathe

Here is another example of MLP utilizing our CNC lathe by using a 304 Stainless Steel flange. The original flange was reverse engineered by MLP for our customer.  After the reverse engineering was completed, the part was produced by using our CNC lathe and our Haas CNC milling machine.  MLP was not only able to reverse engineer, but also produce … Read More

Machined Bottom Receiver

MLP machined this bottom receiver, it was made to a customer’s sample. The material used to machine the bottom receiver, is A2 Tool Steel, and was heat treated to 60 Rc and then surface ground. Machined Bottom Receiver

Broaching a Keyway

Another machining service MLP provides is broaching a keyway. Watch this video of MLP broaching a 1/8″ wide keyway. Broaching a Keyway

Case Study:Production Line Halts, OEM item obsolete, MLP’s Reverse Engineering

Case Study:Production Line Halts, OEM item obsolete, MLP’s Solution: Reverse Engineering Case Study:Production Line Halts.  An International medical supplies manufacturer is threatened with a production line coming to a halt.  The manufacturer wants to avoid the production line slowing or worse, shutting down completely, and choking off production of their much needed products. Reason: The OEM supplier of a critical … Read More

Made in the USA by MLP

flat_glass_machine

Made in the USA by MLP with quality precision machine components.  In the image below you can see some of the components made by MLP being used to construct this glass processing machine.  In the foreground of the image you can see the nickel plated pulleys, the zinc plated support plates, the precision drive shafts and several other items all … Read More